If power goes off during LSR or Rubber injection molding operation, and stays off for enough time, the material can set up in the mold and can sometimes be difficult to remove. One solution is to tie city water supply or set up an auxiliary pump that kicks in when power is lost, and add a circuit can to the Mold . . . → Read More: LSR and Rubber Mold Cooling Safety Circuit
|
||
 Comments are closed  Advantage Engineering, LSR Molding, Water Temperature Control  cooling safety, lsr cooling, rubber cooling Isolate your tower water from your process to minimize maintenence on molds and heat exchangersRecently, a Utah medical molder was expanding their operation, and installed what is termed a Closed Loop Water Tower system. Realizing that tower water can contaminate heat exchangers and molds without careful and overly expensive treatment, it was desirable to isolate the water that runs through the tower from the machinery and equipment in the plant. Outdoor space for the tower stand was also an issue due to the location of the facility and the desire to maximize the available property square footage. Advantage Engineering provided a Closed Loop Tower Cell solution. This type of system is designed to Continue reading Closed Loop Water Tower Conventional cooling towers use a LOT of waterThe adiabatic cooling tower, a green tower solution, significantly reduces the amount of water used to cool your process. Under certain conditions, it actually runs in a dry cooling tower mode, wasting no water. When ambient temperatures permit, the tower is acting a a fluid cooler, simply circulating process water through a coil, cooling the fluid with ambient air. This works especially well in cooler climates, or climates with large temperature swings between day and night. In the adiabatic mode, Continue reading Green Cooling Towers |
||
|
Copyright © 2012 Skiba - All Rights Reserved |
||
