Skiba » Advantage Engineering

LSR and Rubber Mold Cooling Safety Circuit

edwardskiba — Wed, 21 Jul 2010 14:17:57 +0000

If power goes off during LSR or Rubber injection molding operation, and stays off for enough time, the material can set up in the mold and can sometimes be difficult to remove. One solution is to tie city water supply or set up an auxiliary pump that kicks in when power is lost, and add a circuit can to the Mold . . . → Read More: LSR and Rubber Mold Cooling Safety Circuit

Closed Loop Water Tower

edwardskiba — Thu, 15 Apr 2010 15:51:44 +0000

Isolate your tower water from your process to minimize maintenence on molds and heat exchangers

Recently, a Utah medical molder was expanding their operation, and installed what is termed a Closed Loop Water Tower system. Realizing that tower water can contaminate heat

exchangers and molds without careful and overly expensive treatment, it was desirable . . . → Read More: Closed Loop Water Tower

Green Cooling Towers

edwardskiba — Mon, 12 Apr 2010 01:08:40 +0000

Conventional cooling towers use a LOT of water

The adiabatic cooling tower, a green tower solution, significantly reduces the amount of water used to cool your process. Under certain conditions, it actually runs in a dry cooling tower mode, wasting no water. When ambient temperatures permit, the tower is acting a a fluid cooler, simply . . . → Read More: Green Cooling Towers